magnet board
Supplies:
metal sheet from hardware store, cut to size, I did a 3x3
fabric
duct tape
ribbon
This was so easy to make, (except the cutting, but my wonderful husband did that for me!) all you do is cut your fabric leaving about 2 inches to fold over the back, pull it tight and tape it down.
Use a punch or a screw driver and a hammer to poke 2 holes in the top for your ribbon and tie it up.
We made this coat rack to hang coats at the bottom. just a 1x4 paint it black and put some hooks on it!
2 comments:
Cute! What kind of hardware store did you get the metal from? I was searching for some a couple months ago and couldn't find any.
lowes, it was hard to find, just ask a salesman.
Post a Comment